Poly JF – Semi-Rigid Joint Filler

Poly JF – Semi-Rigid Joint Filler, Regular Cure

Smith’s Poly JF is a Heavy-Duty, Pourable, Self-Leveling, Moisture Tolerant, 2-component Semi-Rigid Polyurethane Joint Filler for use to fill and protect joint edges subject to traffic erosion and spalling under industrial forklift, caster and vehicular traffic as well as heavy loads. Smith’s Poly JF develops tenacious adhesion to clean, sound and solid substrates such as Concrete, Epoxy Mortars, Cementitious Urethane Mortars, Polymer Modified Concrete Overlays, and a variety of industrial coating systems. Also well suited for crack, spall/gouge and joint repairs up to 5” thick.

Smith’s Poly JF may be shaved in roughly 90 minutes and can be diamond ground in a few hours at 72°F and 50% RH. Final service temperatures should remain between 40°F (4.4°C) to 200°F (93°C) in order to maintain intended properties.

APPROVED SUBSTRATES:

Asphalt
Ceramic, Porcelain, Stone & Quarry Tiles
Coatings (Epoxy, Cementitious Urethane, Polyaspartic, Polyurethane)
Concrete & Polymer Modified Overlays
Properly Prepared Metal (Stainless Steel, Iron, Steel, Copper, Treated Aluminum*)

DOCUMENTS:

HIGHLIGHTS:

Heavy-Duty
- Chemical Resistant
- Flexible
- Tenacious Bond
Fast
- Shave in 90 to 120 minutes
- Dry Grind in 5 to 7 hours
- Forklift Traffic in 8 to 10 hours
- Exposure to steam cleaning within 24 hours
Compatible with traditional floor covering and floor coating systems
High Solids Content – 100% solids
Low Odor & Low VOC’s
- Meets Source Specific Standards Rule 1113 established by AQMD in California
Pour Grade, Self-Leveling
Suppresses Minor Cracks from Telegraphing
Resists Aging & Elasticity Fatigue
Suitable for use over In-floor Radiant Heat systems
May be topcoated with thin-film Polyaspartics & Polyurethanes (less than 8 mils) once hard
No red label required for shipping
Acceptable for use in USDA/FDA/CFIA regulated facilities
- Non-Tainting

Smith Paint Products®