Facebook Instagram Linkedin
Facebook Instagram Linkedin

2200 Paxton Street
Harrisburg, PA 17111-1038
Office: 717.233.8781
Toll Free: 800.466.8781 (US)
Facsimile: 717.232.5199

Since 1929

Smith Paint Products®

2200 Paxton Street
Harrisburg, PA 17111-1038
Office: 717.233.8781
Toll Free: 800.466.8781 (US)
Facsimile: 717.232.5199

Home

Poly JF – Semi-Rigid Joint Filler, Fast Cure

Smith’s Poly JF/FC Fast Cure is a Heavy-Duty, Self-Leveling, Pour Grade, Moisture Tolerant, 2-component Semi-Rigid Polyurethane Joint Filler used for to filling and protecting joint edges subject to traffic erosion and spalling under industrial forklift, caster and vehicular traffic as well as heavy loads.  Smith’s Poly JF/FC yields tenacious adhesion to clean, sound and solid substrates such as Concrete, Epoxy Mortars, Cementitious Urethane Mortars, Polymer Modified Concrete Overlays as well as a variety of industrial coating systems.  Can be applied as thick as 5” in depth and 1.5″ wide in a single lift.

Smith’s Poly JF/FC may be shaved as soon as it is hard set and tack free.  Diamond Grinding may occur in roughly 2 1/2 hours at 72°F with 50% Ambient Humidity.  Final service temperatures should remain between 40°F (4.4°C) to 200°F (93°C) in order to maintain intended properties.

APPROVED SUBSTRATES:

  • Asphalt
  • Ceramic, Porcelain, Stone & Quarry Tiles
  • Coatings (Epoxy, Cementitious Urethane, Polyaspartic, Polyurethane)
  • Concrete & Polymer Modified Overlays
  • Properly Prepared Metal (Stainless Steel, Iron, Steel, Copper, Treated Aluminum*)

HIGHLIGHTS:

  • Heavy-Duty
    • Chemical Resistant
    • Flexible
    • Tenacious Bond
  • Fast
    • Shave in 60 minutes @ 72°F / 50% Humidity
    • Dry Grind in 2.5 to 3.5 hours @ 72°F / 50% Humidity
    • Forklift Traffic in 14 to 18 hours @ 72°F / 50% Humidity
    • Exposure to steam cleaning within 24 hours
  • Pourable, Self-Leveling 2-Component Joint Filler for Interior Control or Construction Joints
  • Compatible with traditional floor covering & floor coating systems
  • High Solids Content – 100% solids
  • Low Odor & Low VOC’s
    • Meets Source Specific Standards Rule 1113 established by AQMD in California
  • Suppresses Minor Cracks from Telegraphing
  • Resists Aging & Elasticity Fatigue
  • Suitable for use over In-floor Radiant Heat systems
  • May be topcoated with thin-film Polyaspartics & Polyurethanes (less than 8 mils) once hard
  • Natural Beige color; accepts Smith’s ISC Color Packs (excluding White or Ivory White)
  • No red label required for shipping
  • Acceptable for use in USDA/FDA/CFIA regulated facilities
    • Non-Tainting
  •  

DOCUMENTS:

Contact Us